Chief PNR Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Telewizory Chief PNR. CHIEF PNR User Manual Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 12
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
INSTALLATION INSTRUCTIONS
Large Flat Panel Dual Arm Wall Mount
Model PNR™
The PNR is wall-mounted, rugged, versatile, and
installer-friendly. The PNR is compatible with the
standard (14” x 14”) PSB interface bracket in which a
display can be mounted in either the landscape or
portrait position on the PNR.
The dual arms on the PNR:
Extend from the wall 25” in length
Pivot up to 90º left or right of center
The standard PNR is shipped with the support posts for
the dual arms centered in the mount. The support posts
can be moved laterally right or left of center to readily
accommodate sites with limited wall space. The mount
also has over an inch of height adjustment. The tilt range
for the display is 5º up and 15º down.
The PNR was designed for fast installation. After drawing
the plumb line and installing the two top lag bolts into the
dual wall studs, the installer hangs the PNR on its top
bracket and installs two lag bolts in the bottom bracket.
Next, the installer makes the height adjustment, mounts
the display, and connects the power/audio/video cables,
which are diverted into the built-in path in the swing-out
arms. After making the lateral, rotational, and tilt
adjustments, the installation process is complete.
BEFORE YOU BEGIN
CAUTION: To prevent damage to the PNR, which could affect or void the Factory warranty, and to the equipment that
will be attached to it, thoroughly study all instructions and illustrations before you begin the installation. Pay particular
attention to the “Important Warnings and Cautions” on Page 2.
The combined weight of the components installed on the PNR must not exceed 200 lbs. (90.72kg).
The PNR wall mount must be installed on dual wall studs or supporting framework. The wall to which the PNR is
anchored must be capable of supporting five times the total weight of the mount and all attached equipment.
Chief Manufacturing, a products division of
Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8831-000007 RevK
©2010 Milestone AV Technologies, a
Duchossois Group Company
www.chiefmfg.com
08/10
Przeglądanie stron 0
1 2 3 4 5 6 ... 11 12

Podsumowanie treści

Strona 1 - Model PNR™

INSTALLATION INSTRUCTIONSLarge Flat Panel Dual Arm Wall MountModel PNR™The PNR is wall-mounted, rugged, versatile, andinstaller-friendly. The PNR is c

Strona 2 - CONTENTS

Model PNR™ Installation Instructions10Figure 14Figure 15Swing Arm Tension AdjustmentSwing arm tension is pre-set at the factory and is adjusted toacco

Strona 3 - DIMENSIONAL DRAWING

Installation Instructions Model PNR™11Figure 18Removing Display from Mount1. Remove bolt or padlock from faceplate (if used).NOTE: The pin may have be

Strona 4 - PARTS LIST

Model PNR™ Installation Instructions12

Strona 5 - INSTALLATION

Model PNR™ Installation Instructions2IMPORTANT WARNINGS AND CAUTIONS!WARNING: A WARNING alerts you to the possibility of serious injury or death if yo

Strona 6 - Adjust Height on the PNR

Installation Instructions Model PNR™3DIMENSIONAL DRAWING

Strona 7 - CABLE MANAGEMENT

Model PNR™ Installation Instructions4Inspect The Unit Before InstallingWARNING: Watch for pinch points. Do not put yourfingers between movable parts.1

Strona 8 - ADJUSTMENTS

Installation Instructions Model PNR™5INSTALLATIONWARNING: Improper installation can result in seriouspersonal injury!WARNING: It is the responsibility

Strona 9 - Swing Arm Adjustments

Model PNR™ Installation Instructions6Figure 2Figure 3Adjust Height on the PNRNOTE: Height adjustment range up to 1.08 inches.To adjust the PNR height:

Strona 10 - Swing Arm Tension Adjustment

Installation Instructions Model PNR™7Mount the Display1. Make sure power is not supplied (turned off) to the displaybefore attempting to mount the dis

Strona 11 - Removing Display from Mount

Model PNR™ Installation Instructions8Figure 8Figure 9ADJUSTMENTSTENSION ADJUSTMENTSVertical Tilt Tension Adjustment1. With display mounted, check for

Strona 12

Installation Instructions Model PNR™9Figure 12Swing Arm AdjustmentsThe dual swing arms are shipped installed in the center of thetop and bottom mount

Komentarze do niniejszej Instrukcji

Brak uwag